Cleaning products and equipment for glass

Borosilicate glassware can be cleaned with a small selection of products and tools. This article describes them and explains solvent safety.

Isopropyl alcohol

Isopropyl alcohol dissolves greasy and sticky residue on glass. It is sold in several concentrations; higher alcohol content dissolves residue faster.

Isopropyl alcohol evaporates without residue, but the glass should still be rinsed with warm water afterwards.

Coarse salt

Coarse salt acts as an abrasive with isopropyl alcohol. The grains do not dissolve in the alcohol and scrub the inside of the glass when shaken.

The salt dissolves and rinses away with warm water.

Brushes, pipe cleaners and plugs

Long, narrow brushes reach inside water chambers and tubes. Pipe cleaners are used in tight passages such as downstems and mouthpieces.

Rubber or silicone plugs seal the openings while shaking the glass, keeping the liquid inside. Plugs come in sizes for 14 and 18 mm joints.

Warm water and temperature

Use warm water to rinse out salt and alcohol. Borosilicate glass withstands temperature changes, but avoid very hot water on cold glass.

Solvent safety

Isopropyl alcohol is flammable. Use in a well-ventilated room, away from open flames and heat sources. Gloves protect skin from drying out.

Keep the bottle closed and out of children's reach. Dispose of used isopropyl alcohol as hazardous waste where required by the municipality.

Frequently asked questions

Why use coarse salt with isopropyl alcohol?
The grains do not dissolve in the alcohol and act as an abrasive against the inside of the glass.
Do silicone plugs tolerate isopropyl alcohol?
Yes, silicone tolerates isopropyl alcohol. Rinse the plugs with warm water after use.
Must glass be rinsed after isopropyl alcohol?
Yes. Rinse with warm water to remove salt and dissolved residue, then let the glass dry.