Rolling paper sizes explained

Rolling papers come in several standard sizes, and the names can be confusing. Single wide, 1¼, king size slim and king size mainly describe length and width. This guide explains the common sizes with approximate measurements, the difference between booklets, rolls and blocks, and how to measure a paper yourself. Measurements vary slightly between manufacturers, so the figures below are approximate.

How to read the size names

The size names come from older paper formats and are not fully standardised. They say something about the length, meaning the long side, and the width, meaning the short side. Length is the clearest difference between sizes. Width determines how much paper overlaps. The word slim means the paper is narrower than the wide version of the same length. When the supplier has stated the measurements, they are shown on the product page in millimetres.

The most common sizes with approximate measurements

Here is an overview of the most common sizes. All measurements are approximate and given as length × width.

Single wide (regular)

Single wide: approximately 68–70 × 36 mm. This is the shortest and narrowest of the common sizes. It is also called regular or single. Single wide is often sold in small booklets with many leaves.

1¼

1¼ rolling paper: approximately 76–79 × 44–48 mm. It is slightly longer and wider than single wide. The name refers to the paper being roughly one and a quarter times the size of single wide. 1¼ is a middle size that is often available in several paper types.

King size slim

King size slim rolling paper: approximately 108–110 × 44 mm. It is as long as king size, but narrower. The narrow width gives less overlap. King size slim is sold both in standard booklets and in packs where filter tips come together with the paper.

King size

King size: approximately 108–110 × 53–55 mm. The length is the same as king size slim, but the paper is wider. It is sometimes called king size wide.

Other formats

There are also formats such as 1½ and double wide. Their measurements vary more between manufacturers, so always check the measurements on the product page.

Cones

Cones are pre-rolled paper shaped like a cone, often with a filter tip at the narrow end. They are sold in roughly the same lengths as papers. Common versions are 1¼ length at approximately 84 mm and king size length at approximately 109–110 mm. The length is usually stated including the tip. Cones are packed in tubes, small boxes or larger boxes. Because the paper is already shaped, the length and the diameter of the open end are what set the versions apart.

Filter tips

Filter tips are stiff paper strips or pre-formed tips that give a firm end. They are sold in booklets of perforated strips, as pre-rolled tips and in wide or narrow versions. The width of the strip roughly determines the diameter once the tip is formed. Wide tips are often proportioned for king size, and narrow tips for single wide and 1¼, but this is a choice rather than a rule. Pre-rolled tips have a fixed diameter, often stated in millimetres. Filter tips come in unbleached and bleached paper, and some are made from thicker card.

Booklet, roll or block

The same paper size can be sold in different formats. The difference lies in how the paper is packed and how much each pack contains.

Booklet

The booklet is the most common format. The leaves are folded inside a small folder, often with a flap or magnetic closure. The number of leaves per booklet varies with size and manufacturer. Many booklets are designed so the leaves can be taken out one at a time.

Roll

A roll is a long strip of paper, often in king size slim width and several metres long. You cut the length you want yourself. A roll gives many lengths from one pack and little packaging per metre. Some rolls are sold in a dispenser.

Block

A block is a larger pack with many leaves, either as several booklets together or as one large stack. Blocks mean less packaging per leaf and suit those who want to keep a supply at home. The blog article on booklets and blocks goes into more detail.

How to measure rolling paper

Lay a leaf flat on a table without stretching it. Measure the long side with a ruler or calliper. That is the length. Then measure the short side. That is the width, and the gum strip is included. Compare the measurements with the overview above. Differences of one or two millimetres between manufacturers are common. For cones, measure the full length from the tip to the open end. For filter tips, measure the width of the strip before it is formed, or the diameter of a pre-rolled tip.

When no measurement is stated

If only the size name is given, you can use the approximate measurements in this guide as a starting point. Ask the shop if you need an exact measurement, for example for a case or a rolling machine.

Material and paper thickness

Size is only one property. Rolling papers are made from materials such as wood pulp, hemp, rice and flax, and they can be bleached or unbleached. Thickness is often described as regular, thin or ultra-thin, without a shared measure. Thin paper is lighter and more translucent, while thicker paper is easier to handle. The guide on choosing rolling paper covers the materials.

Accessories that must match the size

Rolling machines, cases and storage boxes are often made for a specific length. A king size rolling machine does not fit single wide paper, and a case for 1¼ is too short for king size. So check the length of the accessory against the paper you have. Rolling trays have no fixed size, but a tray with high edges makes it easier to keep things tidy.

Frequently asked questions

What is the difference between king size and king size slim?
The length is about the same, roughly 108–110 mm. King size slim is narrower, approximately 44 mm, while king size is approximately 53–55 mm wide.
How big is 1¼ rolling paper?
Approximately 76–79 mm long and 44–48 mm wide. Measurements vary slightly between manufacturers.
Do filter tips fit all sizes?
Yes, filter tips can be combined with any paper size. The width of the strip roughly determines the diameter, so choose the width according to the proportions you want.
Are cones made in the same sizes as papers?
Cones are sold in roughly the same lengths, especially 1¼ and king size. The length is usually stated including the tip.